ANALISIS ALIRAN DAYA TIGA FASA DENGAN METODE KOMPENSASI ADAPTIF UNTUK SISTEM DISTRIBUSI DENGAN UNIT PEMBANGKIT YANG TIDAK TERPUSAT

Authors

  • Agung Budi Muljono
  • I Made Ari Nrartha

DOI:

https://doi.org/10.34151/technoscientia.v0i0.1970

Keywords:

Three phase power-flow, adaptive compensation, dispersed generation, unbalance load

Abstract

Generally study of power-flow used the system presentation with the well-balan-ced load. Presentation like this enabled to solve power-flow used single phase presen-tation. Well-balanced load distribution system is very rare. Condition of unbalance load on distribution system needed the special power flow program which can solve three phase power system.This research made and tested three phase power-flow program with adaptive compensation-based method using the application program MATLAB 6.5.1. This method emphasized to solve power-flow of radial system with balance or unbalance load and dis-persed generation. Result of research showed for the validation of program using standard data 15 bus that is getting of converged to the specified tolerance value (1x10-8) for the various lo-ading condition. Unbalance load caused the power mismatch at same iteration tend to in-crease in linear. Addition load factor at one of phase (phase A) caused power mismatch at same iteration tend to increase by exponential. Dispersed generation gives decrease voltage drop in most of all buses and decrease power loss until 73,64 %. Unbalance load on Airlangga feeder caused increase system loss until 38,09%. The biggest contributions of loss cause by longest branch feeder on bus 4 to 6 equal to 39,68 %. Biggest voltages drop at the end of feeder with average degradation until 0Ð0,0130 pu for balance and un-balance load.

References

Baran, M.E and Staton, E.A., 1997, “Distribution Transformer Models for Branch Current Based Feeder Analysis”, IEEE Trans. Power Systems, Vol. 12, No. 2, pp. 698-703.
Cheng, C.S and Shirmohammadi, D., 1995, “A Three-Phase Power Flow Method for Real-Time Dis-tribution System Analysis”, IEEE Trans. Power Systems, Vol. 10, No. 2, pp 671-679.
Luo, G.X and Semlyen, A., 1990, “Effi-cient Load Flow for Large Weak-ly Meshed Networks”, IEEE Trans. Power Systems, Vol. 5, No. 4, pp.1309-1316.
Nrartha, I.M.A, Arnawan, H dan Sapto N., 1998, “Analisa Aliran Daya Fast Decouple pada Sistem Tenaga Listrik”, Program S-2 Teknik E-lektro Universitas Gadjah Mada Yogyakarta, (tidak dipublikasi-kan)
Rajicic, D., Ackovski, R and Taleski, R., 1994, “Voltage Correction Power Flow”, IEEE Trans. Power Deli-very, Vol. 9, No. 2, pp. 1056 – 1062.
Shirmohammadi, D., Hong, H.W., Se-mlyen, A and Luo, G.X., 1988, “A Compensation - Based Power Flow Method for Weakly Meshed Distribution and Transmission Networks”, IEEE Trans. Power Sys-tems, Vol. 3, No. 2, pp 753-762.
Zhang, X., Soudi, F., Shirmohammadi, D and Cheng, C.S., 1995, “A Dis-tribution Short Circuit Analysis Approach Using Hybrid Compen-sation Method”, IEEE Trans. Po-wer Systems, Vol. 10, No. 4, pp. 2053-2059.
Zhu, Y and Tomsovic, K., 2002, “Adap-tive Power Flow Method for Dis-tribution Systems with Dispersed Generation”, IEEE Power Sys-tems. Vol (?).

Downloads

Published

01-08-2007

How to Cite

Muljono, A. B., & Nrartha, I. M. A. (2007). ANALISIS ALIRAN DAYA TIGA FASA DENGAN METODE KOMPENSASI ADAPTIF UNTUK SISTEM DISTRIBUSI DENGAN UNIT PEMBANGKIT YANG TIDAK TERPUSAT. JURNAL TEKNOLOGI TECHNOSCIENTIA, 1–10. https://doi.org/10.34151/technoscientia.v0i0.1970